No 7 EPDM Masterflash 152-280mm (6 to 11 inch) - Low Temp.

Suitable for profiled sheeting and flat panel surfaces with external pipe diameters of (6 to 11 inch) / 152 to 280mm.

We recommend it for the 5" inch Twin Wall system 

APPLICATION

Suitable for profiled sheeting and flat panel surfaces and is temperature resistance -55°C to 135°C.

CONSTRUCTION
Made of EPDM, these flashing's are compounded specifically for maximum resistance to weathering due to ozone and ultraviolet light.
The one piece construction allows for quick and easy on-site installation - usually taking no longer than five minutes.
The base is designed to form a seal on most panel configurations and roof pitches regardless of pipe location.

INSTALLATION
1. Choose pipe opening and trim using a Stanley knife or scissors.
2. Slide flashing over pipe (you may need to lubricate the flashing with some grease).
3. Form the flashing to the same profile as the roof.
4. Apply sealant (contained in the Fixing Kit).
5. Fasten using the screws and caps (supplied in the Fixing Kit).

TWO Standard Fixing Kits are required to install this flashing.